Model h3140 (Mfg. after 6/02)
-13-
Test Run
once the assembly is complete, test run your
machine to make sure it runs properly.
if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review the
Troubleshooting on page 22.
if you still cannot remedy a problem, contact our
tech support at (570) 546-9663 for assistance.
To test run the machine:
1. perform Sanding Belt Tracking on page 17.
2. Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is set up properly.
3. Make sure all tools and objects used during
setup are cleared away from the machine.
4. turn the machine
on
.
5. listen and watch for abnormal noises or
actions. the machine should run smoothly
with little or no vibration or rubbing noises.
— strange or unusual noises should be inves-
tigated and corrected before operating the
machine further. always disconnect the
machine from power when investigating or
correcting potential problems.
6. turn the machine
off
.
