Model H3253, H3254, H3255 Spray Gun
-7
-
Prior to assembly and use of the spray
gun, it is essential that all parts be thor-
oughly cleaned and dried. Please refer to
Cleaning
in the
MAINTENANCE
section
on
Page 13
for more detailed instructions.
Make sure all connections are tight enough
to prevent air leaks but not so tight as to
damage the tool.
1.
Screw the filter on the bottom of the
feed tube as shown in
Figure 4
(Model
H3254 only).
Assembly
Figure 4.
Installing H3254 filter.
3.
Attach the air hose to the spray gun
using the barbed hose fitting provided
(Models H3253, H3254, H3255) or with
a
1
⁄
4
" NPS quick connect fitting (not
included).
4.
Attach the spray gun to a filtered, regu-
lated air source. See the
Tool Data
Sheet
on
Page 5
for your spray gun air
requirements.
Note:
For the best results, use a hose
that will be dedicated for spray use
only. Do not use a hose that has been
used with an in-line oiler or other pos-
sible contaminant.
If you need additional help with this assem-
bly, call our Technical Support at: (570)
546-9663.
Figure 5.
Installing cup.
2.
Remove/install cup by loosening/tight-
ing the cup lock and engaging/disen-
gaging the hooks to the cup pins (see
Figure 5
). For the Model H3254, the
cup is simply screwed on.
