H7943 /H7944 Framing Nailer
-8
-
OPERATIONS
Loading
Figure 3.
Loading nails in the magazine.
Use nails meeting these specifications:
Model H7943
Nail Type: Round Head
Strip Angle: 21º
Nail Diameter: 0.113" - 0.161"
Nail Length: 2"– 4"
Magazine Capacity: 66 nails.
Model H7944
Nail Type: Clipped Head
Strip Angle: 34º
Nail Diameter: 0.113" - 0.148"
Nail Length: 2"– 4"
Magazine Capacity: 90 nails.
To load nails in your nailer:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
Figure 4.
Pulling the pusher back.
3.
Pull the pusher to the rear of the maga-
zine, as shown in
Figure 4
.
4.
Slide the nails forward.
5.
Point the nailer away from you. Release
the pusher until it contacts the nails, as
shown in
Figure 5.
(Do not let it snap).
Figure 5.
Releasing the pusher.
2.
Slide a strip of nails into the magazine
from the rear; and slide them past the
nail stopper, as shown in
Figure 3.
Point the nailer away from you and
others when connecting the air supply.
The nailer can cycle and discharge a
nail when the air supply is connected.
Ignoring this warning may result in
serious personal injury.
