H7943 /H7944 Framing Nailer
-9
-
Unloading Nail Strips
To remove unused nails:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2.
Point the nailer away from you.
3.
Pull the pusher back from the nails,
then press the pusher lock down as
shown in
Figure 6.
Figure 7.
Pressing the nail stop down.
Nail Stop
Figure 6.
Pulling the pusher back and
releasing the pusher lock.
4.
Slide the pusher over the unused nails
to the front of the magazine.
5.
Slide unused nails back and push the
nail stop down as shown in
Figure 7.
Rotating The Exhaust
Cover
The exhaust cover rotates as needed to
direct the exhaust away from you.
To rotate the exhaust cover, do these
steps:
1.
Use the 5MM hex wrench to loosen the
exhaust cover cap screw as shown in
Figure 8.
Figure 8.
Loosening the exhaust cap
screw.
Exhaust
Cap Screw
6.
Slide the unused nails over the nail
stop and out the back of the nailer.
2.
Rotate the exhaust cover by hand to
aim the exhaust port in the desired
direction.
3.
Tighten the exhaust cover cap screw.
Pusher Lock
