5.3. Selector plate
Insert prepared selector plate into position of your gearbox (pict.3). Check if the magnet is right above the probe,
when selector is set on semi. If not, adjust magnet on selector plate. If you modify your own selector plate, you
need to remove conductive contacts and remove part of selector plate where it meets cut-off lever. Finally, stick
the magnet on selector, so it is above the probe when selector plate is set on semi (pict.5). For better magnet
placing, we recommend to mill a slot for magnet and insert magnet in. Magnet polarity does not matter.
Pict.3: Maded modifications on selector plate
Pict.4: Represetation sensor of selector plate
Summary of Contents for PSJ-M2 gen3
Page 1: ......
