5.5. Trigger prepartion
Remove the top part of the trigger, so the top is in the same level
(pict.10)
. Insert trigger into your gearbox and
check if it goes smoothly. If not, adjust your trigger. Set the trigger to position, where you want your replica to
fire and mark the center of the probe. If you wish your trigger to be more sensitive, use rectangular magnet and
place it the way, that it is in contact with probe until trigger is fully pressed
(pict.11)
.
If needed, you can very
gently bend the probe to be very close to magnet, but not to touch it.
Pict.10: Trigger adjustment (top) and magnet position
Pict.11: Magnet position on trigger, probe almost touching the magnet
5.6. Replica completion
Assemble the rest of your gearbox in standard way and insert it into your replica. You can now test your PSJ-M2
and set your prefered fire mode.
Summary of Contents for PSJ-M2 gen3
Page 1: ......
