6. Fire modes and programming
6.1. Preset modes
Selector on semi: Selector on auto:
1. Semi
Burst / Auto
2. Semi
Auto
3. Semi
Semi
4. Semi
Burst only
5. Burst only
Auto
6. Burst only
Burst / Auto
6.2. Unit programming
a)
For programming, connect battery and within 5 seconds press and hold trigger for another 5 seconds.
Entering is confirmed by motor vibrating twice.
b)
Next, choose category from menu by pressing trigger as many times as is the number you wish to select.
c)
After that, press and hold trigger for 5 second to enter submenu. Your choise is confirmed by motor
vibrating as many times as is selected number.
d)
When changing fire mode (menu 3), every trigger press is followed by motor vibrating as many times as is
selected number of fire mode. Submenu goes in cycle, after number 6 follows number 1.
e)
When you are done with setting value, press and hold trigger for 5 seconds to save your settings. Double
vibration confirms successful saving and exiting programming function.
Category
(choice confirmed by vibrating in
count of selected number)
Value
(after you select value, confirm it by holding trigger for 5s)
1) Burst setting
Number of trigger presses = number of shots on burst
(default = 3 shots)
2) Battery check setting
1) Li-Pol, Li-Ion (default)
2) Li-Fe
3) Off (recommended for Ni-MH, Ni-CD)
3) Fire mode setting
1) Semi - Burst/Auto (default)
2) Semi - Auto
3) Semi - Semi
4) Semi - Burst only
5) Burst only - Auto
6) Burst only - Burst/Auto
(selection in this submenu is confirmed by vibrating in count of
selected number)
4) Shooting delay setting
Every trigger press = +20ms
(everytime you set delay, you start from default value - for
default value, just hold trigger for 5s)
5) Reset to default values
(returns all settings to their default
values)
Hold trigger for 5s to confirm restart. If you do not wish to
restart your settings, disconnect your battery.
6) Rate of fire setting
each trigger pull = - 10% ( everytime you set, you start from
default value for default value, just hold trigger for 5s) – range
100% - 0%
7) Active brake setting
each trigger pull = -10% ( everytime you set, you start from
default value for default value, just hold trigger for 5s, when
0% is set active brake is turned off) – range 100% - 0%
*Active brake function is to stop motor immediately by residual energy and prevent incomplete cycle before shot.
Gearbox stops straight after shot and minimize inertial move of gears.
With this function replica runs smoother and saves its gearbox. Power of active brake is adjustable and you can
adjust power of braking or turn brake off.
Summary of Contents for PSJ-M2 gen3
Page 1: ......