-24-
Model T32335 (Mfd. Since 11/20)
Some water may accumulate in the tank depend-
ing on usage and humidity. Drain water from the
tank daily to increase the lifespan of the compres-
sor and air tools and to prevent tank corrosion.
Draining Tank
Figure 28. Drain valve handle open.
Drain Valve
Handle
The air filter helps prevent impurities and dust
from entering the compressor and reduces noise.
A dirty filter will result in a less efficient system
and could become a fire hazard.
Checking Air Filter
To check air filter:
1. DISCONNECT MACHINE FROM POWER!
To drain tank:
1. DISCONNECT MACHINE FROM POWER!
Releasing air through safety relief valve
can be extremely loud. Protect hearing
with ANSI-approved hearing protection in
following step.
2. Use safety relief valve to reduce tank pres-
sure to less than 10 PSI.
3. While holding base of filter assembly in place,
turn filter cap counterclockwise to remove
cap (see
Figure 29).
Figure 29. Air filter assembly components.
— If filter is fairly clean and there has not
been a drop in efficiency of compressor,
replace cap. No replacement is required.
— If filter is dirty or clogged, or there has
been a drop in efficiency of compressor,
replace cap. Proceed to
Step 4.
4. Turn filter assembly base counterclockwise
to remove, then replace with new air filter
assembly (refer to Part #38 in
Parts begin-
ning on
Page 35).
Base
Cap
2. Use safety relief valve to reduce tank pres-
sure to less than 10 PSI.
3. Open drain valve (see Figure 28) to drain
condensation from tank.
Releasing air through safety relief valve
can be extremely loud. Protect hearing
with ANSI-approved hearing protection in
following step.
Summary of Contents for QUIET Series
Page 40: ......
