t10499/t10500 Blade Welder
-5-
T10499 Circuit Requirements
this machine is prewired to operate on a 115V
power supply circuit that has a verified ground and
meets the following requirements:
Nominal voltage ........................................ 115v
Cycle ..........................................................60 hz
Phase ........................................... Single-Phase
Power Supply Circuit ......................... 15 Amps
Plug/Receptacle ............................. NEMA 5-15
this machine is equipped with a power cord
and plug that have an equipment-grounding wire
and a grounding prong (see
figure 3). the plug
must only be inserted into a matching receptacle
(outlet) that is properly installed and grounded in
accordance with all local codes and ordinances.
T10500 Circuit Requirements
this machine is prewired to operate on a 230V
power supply circuit that has a verified ground and
meets the following requirements:
Nominal voltage ........................................230v
Cycle ..........................................................60 hz
Phase ........................................... Single-Phase
Power Supply Circuit ......................... 20 Amps
Plug/Receptacle ............................. NEMA 6-20
the provided power cord and the plug specified
above have an equipment-grounding wire and a
grounding prong. the plug must only be inserted
into a matching receptacle (outlet) that is prop-
erly installed and grounded in accordance with all
local codes and ordinances (see
figure 4).
figure
3
. typical 5-15 plug and receptacle.
Grounding Prong
Neutral Hot
5-15 PLUG
GROUNDED
5-15 RECEPTACLE
SHOCK HAZARD!
Two-prong outlets do not meet the grounding
requirements for this machine. Do not modify
or use an adapter on the plug provided—if
it will not fit the outlet, have a qualified
electrician install the proper outlet with a
verified ground.
figure
4
. typical 6-20 plug and receptacle.
Grounding Prong
Current Carrying Prongs
6-20 PLUG
GROUNDED
6-20 RECEPTACLE
No adapter should be used with the
required plug. If the plug does not fit the
available receptacle, or the machine must
be reconnected for use on a different type
of circuit, the reconnection must be made
by a qualified electrician and comply with all
local codes and ordinances.
