Model T27417 (Mfd. Since 09/15)
-15-
Assembly
Place the spindle nut, table inserts, sanding
drums and sleeves, spindle washers, edge-sand-
ing attachment, and spindle nut wrench in the
appropriate accessory slots beneath the table
(see
Figures 11–12). A sanding drum does not
need to be installed until after the test run.
Figure 11. Assembled sander (front).
Figure 12. Assembled sander (rear).
Dust Collection
To connect dust collection system to machine:
1. Fit 1
1
⁄
2
" dust hose over dust port, as shown in
Figure 13, and secure with a hose clamp.
2. Tug the hose to make sure it does not come
off.
Note: A tight fit is necessary for proper
performance.
Recommended CFM at Dust Port: 100 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
This machine creates a lot of wood chips/
dust during operation. Breathing airborne
dust on a regular basis can result in perma-
nent respiratory illness. Reduce your risk
by wearing a respirator and capturing the
dust with a dust collection system.
Figure 13. Dust hose attached to dust port.
Summary of Contents for T27417
Page 44: ......
