-14-
Model T28360 (Mfd. Since 11/18)
To lift and move machine:
1. DISCONNECT MACHINE FROM POWER!
2. Drain water from tray by pulling drain plug
(see
Figure 7).
3. Move carriage assembly to middle of
slides, and then tighten slide lock knob (see
Figure 7) to secure carriage assembly in
position.
4. Lift machine by handle (see Figure 7) and
move to prepared location.
Lifting & Moving
The Model T28360 is light enough for one person
to lift and move the machine a short distance.
Connecting Power
When connecting the plug to an outlet, ensure the
lowest point of the cord loop is lower than the out-
let the plug is connected to. This helps to ensure
water will "drip" from the cord and not get into the
power receptacle.
Drip Loop
Figure 8.
Connecting to power with a drip loop.
Disconnecting Power
Figure 9.
Disconnecting power.
Turn the machine
OFF. Grasp the plug and pull
it completely out of the receptacle. When discon-
necting the plug from the outlet, ensure the plug,
receptacle, and your hands are dry.
Power Connection
After you have completed all previous setup
instructions and circuit requirements, the machine
is ready to be connected to the power supply.
To avoid unexpected startups or property dam-
age, use the following steps whenever connect-
ing or disconnecting the machine from the power
supply.
1. Turn the machine power switch OFF.
2. Grasp the molded plug and pull it completely
out of the receptacle. DO NOT pull by the
cord as this may damage the wires inside.
Figure 7. Components for lifting and moving
machine.
Slide Lock Knob
Slides
Handle
Drain Plug
