-4-
T30027 Pocket Hole Guide (Mfd. 2/19+)
Adjusting Pocket Hole Spacing
The Pocket Hole Guide can provide approxi-
mately 1
1
⁄
8
" to 3" of spacing between pocket hole
centers while clamped in a single position.
2. Move columns to desired measurement, as
referenced on the scale shown in
Figure 14.
To adjust spacing:
1. With 4mm hex wrench, loosen button head
cap screw beneath scale until columns slide
freely on column pin (see
Figure 13).
Figure 13. Button head cap screw location.
Button Head Cap Screw
Column
Pin
Figure 14. Inside of column against scale.
Inside
Columns
Scale
3. Tighten button head cap screw.