-22-
Model T30945 (Mfd. Since 12/19)
Miter Guide
Lock Knob
Making L-Cuts
For corners and other tough-to-fit places, you may
need to make an L-cut, or make two separate cuts
that do not extend the full length of the tile, as
shown in
Figure 30.
Figure 30. Example of an L-cut.
L-Cut Tile
Wall Corner
5. Loosen splash hood lock knob and adjust
hood to height of tile (see
Figure 28). Hood
should be as close to tile as possible without
touching.
To make an L-cut:
1. DISCONNECT MACHINE FROM POWER!
2. Mark bottom of tile with area to be cut.
3. If making an angled cut, loosen miter guide
lock knob, adjust to desired miter angle, and
tighten to secure (see
Figure 31). If rip cut-
ting, remove miter guide.
4. Position tile against tilted table at front of saw.
Figure 31. Miter guide lock knob location.
6. Connect machine to power and turn ON.
7. Ensure blade is wet, then push tile through
cut with a push stick or some other type of
workpiece support (see
Figure 29).
Figure 28. Splash hood lock knob location.
Splash Hood
Lock Knob
Figure 29. Tile ready for bevel cut.
Top View
Front View
Tile
Summary of Contents for T30945
Page 40: ......
