Model T31634/T31635 (Mfd. Since 8/19)
-33-
= Top
Table Insert
Workpiece
Fence
= Line of cut
Finished
Piece
Figure 56. Inside corner, right side.
= Top
Table Insert
Workpiece
Fence
= Line of cut
Finished
Piece
Figure 57. Outside corner, left side.
= Top
Table Insert
Workpiece
Fence
= Line of cut
Finished
Piece
Figure 58. Outside corner, right side.
Adjusting Depth
To perform "non-through" cuts, adjust the depth
of cut on the Model T31634/T31635 as described
below.
To adjust depth of cut:
1. DISCONNECT MACHINE FROM POWER!
2. Raise cutting head all the way up.
3. Loosen depth stop plate screw (see Figure
59) and slide plate forward until stop screw
will not pass through plate hole when cutting
head is pulled down. Retighten screw.
4. Pull cutting head down until blade teeth reach
desired depth of cut. Hold cutting head in this
position and turn stop screw until it contacts
plate (see
Figure 59).
5. Tighten knurled nut to secure setting (see
Figure 59).
Figure 59. Depth adjustment hardware.
Stop Screw
Depth Stop
Plate
Knurled Nut
Depth Stop
Plate Screw
6. Perform test run by pulling cutting head down
and through full motion of typical cut to con-
firm desired depth is set.
Summary of Contents for T31634
Page 64: ......
