-44-
Model T31634/T31635 (Mfd. Since 8/19)
5. Unlock the bevel lock lever and adjust set
screws at either side of bevel scale (see
Figure 83) until saw blade aligns with frame.
6. Lock bevel lock lever.
Figure 83. Bevel adjustment screws.
7. Check bevel scale indicator to see that it
points at zero on scale. If it does not, loosen
indicator screw and reposition before tighten-
ing to secure.
Your miter saw was calibrated at the factory
so it shouldn't require any further adjustment.
However, in the case that your saw is knocked
out of alignment, follow these steps to check and
adjust its accuracy.
Squaring Blade To
Table (Bevel)
To check bevel angle for squareness to table:
1. DISCONNECT MACHINE FROM POWER!
2. Set bevel angle to zero as described on Page
19.
3. Pull cutting head down and lock.
4. Lay a framing square flat on miter table
pressed against flat part of blade (not teeth)
(see
Figure 82).
Tools Needed
Qty
Framing Square ................................................. 1
Hex Wrench 3mm .............................................. 1
Phillips Head Screwdriver #2 ............................ 1
Fence
Frame
Blade
Table
— If frame is flush against both table and
blade then miter is calibrated correctly and
you may proceed to
Step 7.
— If front or back edge of saw blade is not
flush with framing square, proceed to
Step
5.
Figure 82. Framing square positioning for bevel.
Summary of Contents for T31634
Page 64: ......
