-10-
Model T31639 (Mfd. Since 04/20)
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Box Contents (Figure 4)
Qty
A. Dust Enclosure ........................................... 1
B. Y-Fitting 4" x 4" x 2
1
⁄
2
" ................................ 1
C. Switch Box .................................................. 1
D. Dust Hose 2
1
⁄
2
" x 28" .................................. 1
E.
Strain Relief
1
⁄
2
"
.......................................... 1
F. Star Knob
1
⁄
4
"-20 x
1
⁄
2
" ................................ 1
G
.
Hose Clamps 3" ......................................... 2
H.
Hex Bolts
1
⁄
4
"
-20 x 2
1
⁄
2
"
............................... 2
I. Flat
Washers
1
⁄
4
" ......................................... 2
J
.
Phillips Head Screws 10-24 x
3
⁄
8
"
............... 6
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to
Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To install switch box and dust enclosure:
1. Attach switch box (see Figure 5) to leg of
your router table stand with pre-installed
clamp and (2)
1
⁄
4
" -20 x 2
1
⁄
2
" hex bolts and (2)
1
⁄
4
" flat washers.
Figure 6. Example of attaching dust enclosure to
your table.
2. Install dust enclosure (see Figure 6) under-
neath your router table with (6) 10-24 x
3
⁄
8
"
Phillips head screws.
Note: The vent should be facing the front of
your table.
Figure 4. Inventory.
B
C
D
A
H
I
J
E
F
G
Figure 5. Example of attaching switch box to a
stand.
Electrical
Box
x 2
x 6
Summary of Contents for T31639
Page 20: ......