Model T31639 (Mfd. Since 04/20)
-13-
To test run router table:
1. Clear all setup tools away from router table.
2. Make sure paddle switch is set to OFF
position.
3. Make sure router power cord is plugged into
110V receptacle in switch box.
4. Connect router table power cord to power
supply.
5. Reach into dust enclosure and turn router
ON.
6. Using paddle switch, turn router table ON,
verify router powers up, and then turn router
table
OFF.
7. Remove switch-disabling key, as shown in
Figure 12.
8. Try to start router with paddle switch. The
router should not start.
— If router does not start, switch disabling
feature is working as designed.
— If router does start, immediately stop rout-
er. The switch disabling feature is not work-
ing correctly. This safety feature must work
properly before proceeding with regular
operations.
9. Re-install switch-disabling key in paddle
switch.
Congratulations! The test run is complete.
The router table is ready for operation.
Figure 12. Removing switch key from paddle
switch.
Summary of Contents for T31639
Page 20: ......