-24-
Model T32003 (Mfd. Since 02/20)
This machine is equipped with a universal motor
that uses two carbon brushes to transmit electri-
cal current inside the motor.
These brushes are considered to be regular
"wear items" or "consumables" that will need to
be replaced during the life of the motor. The fre-
quency of required replacement is related to how
much the motor is used and how hard it is pushed.
Replace both carbon brushes at the same time
when the motor no longer reaches full power, or
when the brushes measure less than
3
⁄
16
" long
(new brushes are
3
⁄
8
" long).
Items Needed
Qty
Phillips Head Screwdriver #2 ............................ 1
Carbon Brushes (PN PT32003014) ............1 Pair
To replace motor brushes:
1. DISCONNECT MACHINE FROM POWER!
2. Remove brush caps, brush springs, and worn
brushes from motor (see
Figure 23).
Figure 23. Location of motor brushes.
3. Replace both motor brushes and re-install
with springs and brush caps.
Replacing
Motor Brushes
Brush
(1 of 2)
Cap
(1 of 2)
Spring
(1 of 2)
Summary of Contents for T32003
Page 32: ......
