-14-
Model T32003 (Mfd. Since 02/20)
Assembly
There is a range of options when it comes to buff-
ing and polishing wheels, but two 4
1
⁄
2
", 50-ply cot-
ton wheels are included with the Model T32003.
To assemble machine:
1. Place (1) tapered spindle sleeve on each
spindle shaft on each side of buffer (see
Figure 8).
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to
Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
Note: Pre-installed set screws in spindle
sleeves should line up with flats on spindle
(see
Figure 9).
2. Tighten (2) pre-installed set screws on each
sleeve to secure sleeves on spindle shaft.
Note: Sleeve is not correctly installed if
spindle flat is visible. Sleeve should cover
entire spindle flat on each side.
3. Thread a buffing wheel onto either tapered
spindle sleeve (see
Figure 10).
Figure 9. Set screws aligned with spindle flat.
Set Screws
Spindle Flat
(1 of 2)
Figure 10. Buffing wheels threaded onto tapered
spindle sleeves.
Buffing Wheel
(1 of 2)
Figure 8. Tapered spindle sleeves on spindle.
Spindle
Tapered
Spindle Sleeve
(1 of 2)
Note: Left spindle sleeve has left-hand
threads so buffing wheel threads counter-
clockwise onto sleeve.
Summary of Contents for T32003
Page 32: ......
