-26-
Model T32339 (Mfd. Since 03/21)
Changing Oil
To change oil:
1. DISCONNECT MACHINE FROM POWER!
2. Remove oil fill plug (see Figure 33).
3. Place drain pan under oil drain plug, then
remove oil drain plug (see
Figure 33).
Items Needed
Qty
Drain Pan ........................................................... 1
Wrench or Socket 14mm ................................... 1
Wire Brush ......................................................... 1
Thread Sealing Tape ......................... As Needed
Model T28041 (or SAE 30 Equiv.) ............... 1 Qt.
Figure 33. Location of oil fill and oil drain plugs.
4. Clean drain plug threads.
5. When oil is fully drained, wrap drain plug
threads with thread sealing tape, then install
drain plug.
6. Add compressor oil until oil level is between
bottom and top of red circle on oil sight glass
(see
Figure 32 on Page 25), then install fill
plug.
The air filters help prevent impurities and dust
from entering the compressor and reduces noise.
A dirty filter will result in a less efficient system
and could become a fire hazard.
To check air filters:
1. DISCONNECT MACHINE FROM POWER!
Checking Air Filters
— If filter is fairly clean and there has not
been a drop in efficiency of compressor,
replace cap. No replacement is required.
— If filter is dirty or clogged, or there has
been a drop in efficiency of compressor,
replace cap. Proceed to
Step 4.
4. Replace old filter with new filter element (refer
to Part #16 in
Parts beginning on Page 41).
5. Repeat Step 3 for second filter.
Figure 34. Air filter assembly components.
Releasing air through safety relief valve
can be extremely loud. Protect hearing
with ANSI-approved hearing protection in
following step.
Cap
2. Use safety relief valve to reduce tank pres-
sure to less than 10 PSI.
3. Remove wing nut shown in Figure 34 to
remove filter cap and access filter.
Oil Drain
Plug
Oil Fill
Plug
— If oil level is below bottom of red circle,
proceed to
Step 2.
2. DISCONNECT MACHINE FROM POWER!
3. Remove oil fill plug (see Figure 32 on
Page 25).
4. Add compressor oil until oil level is between
bottom and top of red circle, then install fill
plug.
Summary of Contents for T32339
Page 48: ......
