GRIZZLY YM 203
3
Do not seek in any military areas!
Leave the ground and vegetation
the way they were. Bury every hole
you have dig!
Use the metal detector only in safe
places!
Collect the waste you find and
throw it only in the determined
locations. Do not leave it to be
found by the next keeper!
PREPARATION
1.
Assembling the metal –
detector.
Assembling the metal detector is
easy and you do not need any
special skills and tools to do it. Just
follow these steps:
- connecting the searching coil:
Release and take out the nut,
tighten up the searching coil, put
the handle of the metal detector in
the cramp of the searching coil. Put
back the screw in the hole and
tighten up the nut. Now the
searching coil is connected to the
handle.
- adjusting the length of the
handle:
a) Turn the locking nut of the
handle clockwise until it loosens.
b) Pull the plastic handle, that is
below the handle of the metal
detector. Prolong or shorten the
handle, so that when you stand up
holding
the
equipment,
the
searching coil to be 2 to 5 cm
above the ground level, with your
hand loosen. Then tighten up the
nut of the handle.
- connecting the cable of the
searching coil:
(1) Wind up the cable of the
searching coil around the handle.
Leave the cable loose enough, so
you can adjust the searching coil
when you operate on rough
ground.
(2) When you put the plug of the
searching coil in the swich of the
control panel, make sure all the
pins of the plug are in the
respective holes.