Saber Hand Wind Audio Player - Maintenance Guide
Insert green circuit board as shown
in the photo.
(Tilt board so DC and audio
sockets touch the case first.)
Screw 5 screws into circuit board.
Connect speaker wire into the left
connector on the circuit board.
Connect the generator wire into the
middle connector on the circuit
board.
Board Test
If possible, insert SD memory card
and connect an external DC power.
(If no DC power is available,
connect battery)
Turn on the Saber player.
Make sure all 8 buttons work by
pressing each button and listening
for the appropriate change in the
audio program.
(If a button doesn't work, please
replace the switch pusher)
Crank handle
Place a small amount of grease on
the shaft of the crank handle.
Locate the handle in the front of
the Saber player.
Place the black gear on the crank
handle shaft.
Using long nose pliers, place roll
pin into the hole in the handle as
shown in the photo.
Make sure the wires are not
impeding or touching the black
gear.
Connect Battery Connect the battery wires into the
right connector on the circuit
board.
Page 18 of 30