MAINTENANCE MANUAL ASTIR CS
Rev. 9 28. Nov. 2005
7
Annual Inspection
During each annual inspection
check front and rear attachment for noticeable play
before de-rigging the horizontal stabilizer. Therefore move the stabilizer at the tips
carefully to all directions.
•
If play is noticed in the front attachment the spherical bolt must be replaced (see
figure 1). Determine the ball diameter. When ordering advise the measured diameter
"D" + 0.1 mm. Also advise gap width “S” as measured.
•
Remove spherical bolt from elevator. Check bolt for cracks.
•
Upon re-installation apply correct torque. (20 Nm, tol4 / -2). (NOTE: See
also MSB 306-38).
•
if play is noticed in the rear attachment the retaining pins 102-2142.46 must be
replaced as follows: (refer to figure 2):
•
remove horizontal stabilizer.
•
loosen nut M8, hold bolt using a screwdriver.
•
during removal of the bolts pay attention that the large washers remain on the
aluminum plate.
Torque with 13 Nm
Figure 2
Summary of Contents for Astir CS G102
Page 4: ......
Page 8: ...FLIGHT MANUAL ASTIR CS Rev 9 28 Nov 2005 8...
Page 19: ...FLIGHT MANUAL ASTIR CS Rev 9 28 Nov 2005 19 ASTIR CS Serial No 1438 1536...
Page 29: ......