OM-DH/INA/2-100 13
The kettle can be filled automatically or manually by tapping on the
FILL
control.
i. In the
AUTO
mode, tap on the
WATER FILL SETPOINT
– a display will appear
allowing you to select a desired quantity of Liters and enter them.
Tapping once on the
START FILL
control will initiate water fill through the
faucet. The control will turn bright green during the fill operation and go dark
once the fill setpoint is reached. Automatic fill can be interrupted by either
setting the
FILL
switch to
MANUAL
or pushing in an
EMERGENCY STOP.
ii. In the
MANUAL
mode, press on the
START FILL
control and hold until the
desired quantity of water is delivered through the faucet. The
TOTAL LITERS
counter can be used to observe manual fill operation – press the
RESET
COUNTER
to clear the indication before starting manual fill operation.
iii. Kettle
must not
be allowed to heat without at least 25% of its capacity of
product/water present. The rate-of-Rise feature will shut the kettle down if
there is insufficient product present during heating.
NOTE
: Press
FAUCET
FILL
to minimize the water fill feature on the screen.
Operation
CAUTION
KEEP FLOORS IN FRONT OF KETTLE WORK
AREA CLEAN AND DRY. IF SPILLS OCCUR,
CLEAN IMMEDIATELY TO AVOID THE
DANGER OF SLIPS OR FALLS.
