OM-DH/INA/2-100 15
f. Once the cooking setpoint is reached, the
TURBO HEAT
function can be used to
provide a short burst (factory preset at 30 seconds) of both high and low fire if
needed to fine tune the cooking function.
g. If mains power is interrupted during a cooking cycle, the kettle and display will
power up automatically, but the cook cycle will have to be re-started on the
COOK CONTROL
pop-up display. All of the setting will have been preserved in
non-volatile memory, and will not have to be re-entered.
h. To turn off the cook process, tap the
COOK
switch on the
COOK CONTROL
display to the
OFF
position. Both the
LOW FIRE
and
HIGH FIRE
indicators should
go dark.
i. To empty the kettle, first raise the cover, and then press the
TILT DOWN
button
on the
TILT CONTROL
display to slowly empty the kettle contents into suitable
capacity container(s).
5.
Kettle Shut-Down
a. Clean the kettle thoroughly at the end of a cook cycle, making sure that all
surfaces are free of dirt and cooking material. Sanitize all cooking surfaces, let
dry and rinse clear.
b. Turn
OFF
the control power switch on the front of the right stanchion.
c. If the kettle will remain off for more than one day, turn off the mains power circuit
breaker switch.
PRESSURE GAUGE/INDICATORS/WATER LEVEL
Operation
WARNING
DO NOT STAND IN FRONT OF KETTLE
DURING TILTING. PRODUCT IS HOT AND
WILL CAUSE BURNS. EXERCISE EXTREME
CARE WHED HANDLING OR NEAR
HOT OR BOILING LIQUIDS.
20” to 30” of Vacuum (below 0 mark)
Check Vacuum and Water Level Daily
Top of the Window
(kettle tilted fully upright)
