OM-BPM-E
SYMPTOM
WHO
WHAT TO CHECK
indicates items which must be performed by an authorized technician.
15
Pan will not heat, and
indicator light will not
light
User
a.
That power supply is on.
Auth Service
Rep Only
b.
Fuses, accessible by removing caps on the side of the
control box.
Auth Service
Rep Only
c.
For loose or broken wires.
d.
Thermostat functioning, by listening for a click when
the switch opens or closes.
e.
Contactor functioning.
Pan continues to heat
after it reaches
desired temperature
User
a.
Thermostat dial setting. Turn down if too high.
Auth Service
Rep Only
b.
Thermostat functioning.
c.
Thermostat calibration.
d.
Contactor, to determine if it is de-energized.
Pan does not reach
desired temperature.
User
a.
Thermostat dial setting. Turn up if too low.
Auth Service
Rep Only
b.
Heating elements for ground short or open (burned
out) element.
c.
Thermostat functioning, by listening for a click when
the switch opens or closes.
d.
Thermostat calibration.
e.
Contactor functioning.
Rapid clicking noise
(chattering)
User
a.
For low voltage.
Auth Service
Rep Only
b.
Contactor for dirt or corrosion on the contacts.
Uneven cooking due
to “hot spots.”
User
a.
That the pan body is level
Uneven cooking due
to “cold spots.”
Auth Service
Rep Only
a.
For open (burned out) heating element.
Pan is hard to tilt
(Manual Tilt Models)
User
b.
Gears for foreign materials, lubrication and alignment.
Pan will not tilt
(Power Tilt Models)
User
a. That electrical power supply is on.
b. For overheated actuator motor. Wait 15 minutes for
motor to cool, then operate the power tilt.
Auth Service
Rep Only
c. For blown fuse on motor control circuit - Replace fuse
with Groen approved equal.
d. For damaged DC rectifier and operating relays.
e. Correct setting of upper and lower limit switches.
WARNING
ELECTRICAL POWER MUST BE SHUT OFF BEFORE WORK IS DONE ON INTERNAL
COMPONENTS.
WARNING
USE OF ANY REPLACEMENT PARTS OTHER THAN THOSE SUPPLIED BY GROEN OR THEIR
AUTHORIZED DISTRIBUTORS CAN CAUSE INJURY TO THE OPERATOR AND DAMAGE TO THE
EQUIPMENT AND WILL VOID ALL WARRANTIES.
SERVICE PERFORMED BY OTHER THAN FACTORY-AUTHORIZED PERSONNEL WILL VOID ALL
WARRANTIES.
✗
✗
✗
✗
✗
✗
✗
✗
✗
✗
✗
✗
✗
✗
✗
✗
OM-BMP-E 15
Summary of Contents for Eclipse BPM-30E
