8
Installation
6.Mark the holes in the backplate for wall-
plugs, see Fig. [4].
7.Drill the holes (6mm) for the wallplugs (F)
and fit them into the wall, see Fig. [5].
8.Fix the backplate (D) with set screw (D1)
on top or bottom to the wall with
screws (G), see Fig. [6].
9. Slide the escutcheons (H) over the
supply pipes, see Fig. [7].
10. If flow limiter is mounted in the cold
water connection elbow install filter (J).
11. Slide the mixer body (E) with elbows and
compression nuts loosely over the
supply pipes.
The body must touch the backplate. If
not, check pipes for length again.
12. Fix the mixer body (E) to the back-
plate (D) by tightening set screw (D1).
Do not use excessive force to tighten
the set screw (D1).
13.Tighten the compression nuts (torque
min. 20 Nm), see Fig. [8].
4
5
F
6
G
D
D1
7
E
2.5
mm
D1
H
J
D
8
24
mm
955751.book : i95575gb.fm Seite 8 Mittwoch, September 20, 2000 10:10 AM
