grohe.com
| Page 11
Do not make sharp bends or ”elbows” along the steam pipe. A minimum
radius of 50 mm is recommended. Do not allow sags or “water pockets”
along the steam pipe and/or ventilation duct. All pipes must be completely
isolated.
Caution!
Prevent any type of obstruction along the steam line, such as a stop-
off valve or tap. The internal diameter of the steam pipe must not be reduced.
A connector for 15 mm copper pipe (soft steel pipe) is included. In countries
that do not have this standard, the next higher diameter should be used.
The power supply to the steam generator via the feeder cable must not be
broken. For that reason, avoid switches along the feeder cable.
Make sure the flushing pipe slopes all the way down to the waste outlet.
Caution!
The steam generator’s flushing pipe must always discharge into
a pipe drain siphon outside the steam room itself. The water is very hot
(boiling water).
The ambient temperature outside the steam room and around the steam
generator must not exceed 35°C.
De-scale the steam generator at regular intervals as instructed (please read
the section on ’De-scaling‘ in the TPI of 27 934 000 or 36 362 000. In hard-
water areas, where calcium levels exceed 5-dH, GROHE recommends the
installation of a filter system to avoid scaling.
THE STEAM GENERATOR
IMPORTANT DETAILS!
GROHE Digital Planning_FE_2016.indd 11
19.08.16 08:11
Summary of Contents for F10
