2
GB
The boiling water storage heater with filter system may only
be operated together with an original GROHE Red
®
boiling
water fitting.
Safety notes
GROHE Red
®
boiling water storage heater:
This device is
not
intended for use
by persons (including children) with
physical, sensory or mental impairments
or a lack of experience or knowledge
in using devices of this type.
Children must be supervised to ensure
that they do not play with the device.
Danger due to electric shock. Avoid
damaged power supply cables. In the
case of damage, the boiling water
storage heater must be replaced by the
manufacturer or its customer service
department or an equally qualified person.
• The boiling water storage heater must be connected to
a permanent power supply with earth wire.
• Installation may only be performed in frost-free rooms.
• The boiling water storage heater is only suitable for indoor use.
• The boiling water storage heater must be placed in an
upright position.
• The boiling water storage heater and plug must
not
be
directly or indirectly sprayed with water when cleaning.
The boiling water storage heater must not be opened.
If the boiling water storage heater is to be drained, the safety
assembly of the boiling water storage heater must be removed.
Invert the boiling water storage heater and allow the water to
run out.
However, we strongly advise against draining the boiling
water storage heater. There is a significant risk of
damaging the boiling water storage heater.
Technical specifications
Boiling water storage heater electrical data:
• Connection:
Wall socket with earth wire,
protected with a 16 A fuse
• Voltage supply:
220V AC / 50Hz
• Power consumption:
1,900 W
• Standby power loss (switched on):
15 W
• Standby power loss (switched off):
1 W
• Type of protection:
IPX4
Electrical installation
Electrical installation work must
be performed only by a qualified
electrician. This work must be carried
out in accordance with the regulations
to IEC 60364 -7-701 (corresponding
to VDE 0100 Part 701) as well as all
national and local regulations.
• Extension cables are
not
permitted between the electrical
socket and boiling water storage heater connection.
Installation
Installation see page I and II.
Install storage heater taking into consideration the
available hose lengths.
Do
not
connect voltage supply
yet
.
Filling storage heater with water,
see Figs. [2a/b] and [3a/b].
1. Open shut-off valve (A) at safety assembly, see detail,
Fig. [2a/b].
2. Pull button (B1) on handle (B) of fitting outward and turn the
handle anti-clockwise.
3. Fill the storage heater until water comes out of the spout of
the fitting.
4. Connect voltage supply via mains plug (C), see Fig. [3a/b].
5. Press and hold button (D) on storage heater for at least 2
seconds to switch on the storage heater. The red indicator
lamp (D1) indicates that the storage heater is switched on.
Service
If the problem cannot be rectified, disconnect the mains plug
to shut off the voltage supply. Note down the serial number
of the storage heater on the rear of the device and get in touch
with GROHE Customer Service or contact the GROHE
Service Hotline under
TechnicalSupport-HQ@grohe.com
.
Disposal
This category of device does
not
belong in the
domestic waste, but must be disposed of
separately in accordance with the relevant local
national regulations.
The date of installation must be noted on the
maintenance sticker and affixed at a visible location
on the storage heater.
