Page 28
Application Deployment
One of the strengths of the IT51E terminal is its
ability to deploy an application using either a USB
memory stick or a network connection.
The IT51E terminal comes with the FactoryApp
application pre-installed, which makes it very easy to
install and configure a terminal via USB or network.
Deploying a Terminal by Using a USB Memory Stick
Installing and configuring a terminal via USB can be initiated from:
FactoryApp > USB Setup
Terminal Setup > Application > Install from USB
Terminal Setup > USB > Install Application
To prepare a USB memory stick, the following steps are needed:
Create an \IT-Install directory on the USB memory stick
Copy your application file into the \IT-Install directory
Copy the needed firmware image file into the directory (optional)
Note: There must be not more than one application file and one firmware file per terminal type within the \
IT-Install directory.
Some applications support loading a pre-configuration file as part of their wizard. Such files must be named
as itcfg-[APPLICATION-NAME].xml (e.g. itcfg-EasyClock-Verify.xml) and must be located in the root of the
USB memory stick.
