Power
The Advance I/O Blade draws 12V power from the
Controller.
The I/O Blade Power draw is summed as follows:
I/O Blade Quiescent Current = 83 mA max @12V
(1.0W)
I/O Blade Maximum Current (all AUX Output Inputs
grounded, all AUX Output relays active) = 333 mA
@12V (4.0W)
External 12V output (if used) = up to 500 mA max
@12V (6.0W)
Status LED
The main Blade LED Indicator is used to indicate
activity and state. See also the status LED on the
controller.
If the LED is continuously red, the Blade is not
communicating with the controller.
Blade State is reported by fl ashing a code on the LED
every 15 seconds as follows:
5 blue fl ashes
Board is not being monitored.
Probably no download to
controller from Sateon
5 red fl ashes
Wrong device type confi gured,
e.g. Door defi ned on an IO Blade
3 red fl ashes
Out of range device confi gured
5 green fl ashes
No devices confi gured for board
5 yellow fl ashes
Reports electrical issues, such
as current tripped, over voltage,
under voltage, over current,
under current
Blade Activity is reported as follows:
Yellow fl icker (lasts
about 30 seconds)
Firmware download in
progress
Green blink (every 5
seconds)
Board running OK
Blue blink
Read
Yellow blink
Input state change
Red blink
Output state change
Blade LED indicators
Notes
Page 3
Email:
ac-support@grosvenortechnology.com
Telephone:
+44 (0)1279 838000
Web:
www.grosvenortechnology.com
For more information about Sateon, visit the website or contact Technical Support:
