ASSEMBLY
Then, thread the wire through the top rod.
Now, connect the rods by sliding the
bottom rod into the top rod where the lock
bracket is located. When they are
connected at the desired length, pull
down the lock bracket latch to lock them
into place.
After the wire is snapped into place, insert
the rod of the coil unit into the handle unit.
Once inserted, pull up the latch to lock into
place. Make sure everything is secured
into place before use.
7
Assembling the coil unit
Remove the plastic bolts on the top of the
coil. Fit the bottom rod inside the bracket
on the coil. Insert the plastic bolts into the
bracket and through the bottom rod. Then
tighten but do not over tighten.
Thread the wire connected to the coil
through the bottom rod.
Assembling the handle unit
Take the male end of the threaded wire
from the coil unit and plug it into the
female plug on the handle unit. Be careful
to align the white indicator arrow on the
male end of the wire with the alignment
arrow or the bottom of the handle unit to
ensure proper connection.
1
2