MELBURY HE 3800-10000 -
Installation, Use and Maintenance
10.12.2019
Page 3 / 36
WARNINGS AND CONFORMITIES
Symbols used in this document
INFORMATION:
This symbol highlights the remarks.
CAUTION:
Failure to follow these guidelines carries the risk of damage to the facility or to other
objects.
DANGER:
Failure to follow these instructions can cause injury and serious property damage.
Conformity
This boiler fulfils the requirements of the low voltage
directive 73/23/EEC, of the EMC-directive 89/336/EEC
and the efficiency directive 92/42/EEC.
The boiler range with ECA-rating has efficiencies in
conformity with the requirements of the Enhanced
Capital Allowance Scheme (ECA).
CE-certificate: CE 0461
Type marking: 01-226-598 X
Environmental compatibility
This device contains electrical and
electronic elements and should not be
discarded in household waste.
Local regulations in force must be observed.
Steps to be taken in case of danger
Close fuel supply disconnect unit from mains using
emergency stop or main switch (outside of the boiler
room).
Use suitable fire extinguishers to extinguish flames.
Occurrence of gas smell (gas units)
- Ventilate the affected rooms thoroughly by opening
doors and windows.
- Do not use any electronic devices (mobile phone, etc.).
- Do not activate any electrical contacts (light, motor,
lift, doorbell, etc.)
- Do not ignite matches or lighters, and do not
smoke.
- Call the gas board or heating engineer.
The boiler
The boiler room must be lockable and it's external air
openings must conform to the norms prevailing locally.
When in doubt regarding air circulation, measure the
CO
2
count with the burner operating at its maximum
delivery and the room ventilated only by the burner
ventilation air openings and a second time with the
door open. The CO
2
count measured in both cases
must not differ. Should there be more than one unit in
the same room, this test must be performed with all
the equipment operating simultaneously.
Never obstruct the boiler room's air openings, the
burner fan suction opening, and any air ducts and
ventilation.
The equipment must always be protected against
rain, snow, and freezing conditions.
The boiler room must be kept clean and free of
volatile substances that may be sucked into the fan
and clog the inner burner or combustion head air
ducts.
The combustion air must be free of halogens (chlorine
and fluorine compounds). If there is any doubt, the
quality of the combustion air must be ensured with
an external air intake.
!
STOP
