1
Introduction
This hybrid PV inverter can provide power to connected loads by utilizing PV power,
utility power and battery power.
2
1
WARNING!
instructions and cautionary markings on the inverter and all
appropriate sections of this guide.
Before installing and using this inverter, read all
Important Safety Warning
2
Before using the inverter, please read all instructions and cautionary markings on the
unit and this manual. Store the manual where it can be accessed easily.
!
Hybrid inverter
PV module
Battery
Distribution Box
Load
Electric grids
Figure 1.1 Basic hybrid PV System Overview
Depending on different power situations, this hybrid inverter is designed to generate
continuous power from PV solar modules (solar panels), battery, and the utility.
When MPP input voltage of PV modules is within acceptable range (see specification
for the details), this inverter is able to generate power to feed the grid (utility) and
charge battery. This inverter is only compatible with PV module types of single
crystalline and poly crystalline. Do not connect any PV array types other than these
two types of PV modules to the inverter. Do not connect the positive or negative
terminal of the solar panel to the ground. See Figure 1 for a simple diagram of a
typical solar system with this hybrid inverter.
Note:
allowed to charge battery from Utility. The relevant function is automatically disabled
by the software.
By following the EEG standard, every inverter sold to German area is not
This manual is for qualified personnel. The tasks described in this manual may be
performed by qualified personnel only.
General Precaution
Conventions used:
WARNING! Warnings identify conditions or practices that could result in
personal injury;
CAUTION! Caution identify conditions or practices that could result in
damaged to the unit or other equipment connected.
WARNING!
energized when a ground fault is indicated.
Normally grounded conductors may be ungrounded and
!
WARNING!
persons.
This inverter is heavy. It should be lifted by at least two
!
CAUTION!
electrical shock by disconnecting AC, DC and battery power from
the inverter before attempting any maintenance or cleaning or
working on any circuits connected to the inverter. Turning off
controls will not reduce this risk. Internal capacitors can remain
charged for 5 minutes after disconnecting all sources of power.
Authorized service personnel should reduce the risk of
