7
8
Launch SolarPowerPro in computer and select Device Control >> Parameter Setting
>> Parallel output. Two options: Enable or Disable.
If you want to use parallel function, please choose “Enable” and press “ ”
button. Then, “ ” button will be shown is the screen. Please be sure to click
“ ” button before clicking “ ” button.
There is a “Sync” button in each parameter setting. When “Sync” is clicked and
“Apply” is pressed, this new setting will be applied to all inverters. If not, this setting
is only effected in current inverter you choose.
Note: Without centralized monitoring system, “Sync” function is not effective. Then,
you have to set up the inverter one by one through serial communication port.
Parallel for output: Enable
Parallel for output: Disable
