41
42
2. Slightly loosen the swivel nut, remove the filler-plug from the M16 cable gland.
Information
Pull cables outwards to confirm whether they are installed firmly
3. Make the cable through the hole of cable gland and put the cable into the Rs485
terminals, fix all cables with screwdriver (‘1’to’ T/R-(B)’, ‘3’to’ T/R+(A)’, ‘2’ to the
shielding layer or no connection). The type of cable is recommended as STP, FTP,ASTP.
4. Plug in two terminals. Cover the fix board.
Information
Tighten 4 pcs screws first, then tighten cable gland.
5. Tighten 4pcs screws and cable gland.
Note:
1)
As to the connection between inverters, please refer to the following figure.
2)
As to the connection between inverter and ShineWebBox, please refer to the
following figure.
6.5.4 Inverter demand response modes (DRMs,only for Australia)
This series inverter has the function of demand response modes, We use RJ45 socket
as inverter DRED connection.
6.5.4.1
Definitions of RJ45 socket pins as follows: