Product Description
3
3.1 Inverter overview
Position
Description
7
8
A
LCD
B
LED
C
Rs232 & DIP switch for RS485 configuration
and External communication accessories power
D
AC output
E
RS 485
F
DRM PORT(Only for Australia)
G
DC switch
H
*
PV input terminals
I
Series Number
J
Type label
* 3000-6000TL3-S 7000-11000TL3-S & 12000TL3 2 pairs,12000-15000TL3-S 3
pairs.
&
All operations regarding transport, installation and start-up,
including maintenance must be operated by qualified, trained
personnel and in compliance with all prevailing codes and
regulations.
Anytime the inverter has been disconnected from the power
network, use extreme caution as some components can retain
charge sufficient to create a shock hazard; to minimize occurrence
of such conditions, comply with all corresponding safety symbols
and markings present on the unit and in this manual.
In special cases, there may still be interference for the specified
application area despite maintaining standardized emission limit
values (e.g. when sensitive equipment is located at the setup
location or when the setup location is near radio or television
receivers).In this case, the operator is obliged to take proper action
to rectify the situation.
Possible damage to health as a result of the effects of radiation!
Do not stay closer than 20 cm to the inverter for any length of
time.
CAUTION
Symbol
Explanation
2.6 Symbols on the inverter
Electrical voltage!
Risk of burns!
Point of connection for grounding protection.
Direct Current (DC)
Alternating Current (AC)
CE mark.
The inverter complies with the requirements of the applicable EC
guidelines.
Operation after 5 minutes
EU waste electrical and electronic equipment (WEEE) label
Read the manual
