5.3.3
Fixed the inverter on a wooden wall
5.3.4
Hang the inverter on the wall
Using the mounting frame as a template, drill holes as illustrated in follow image:
Hole size: 0.31*2.0inch/8*50mm(diameter)*(depth,at least), then insert four explosion
bolts into the holes, make sure the bolts paralleled with the outer surface of the
bracket. One screw on the upper left side, one screw on the upper right side, one
screw on the below left side, and the last screw on the below right side.
5.3.2 Fixed the Inverter on a concrete wall
Falling equipment can cause serious or even fatal injury, never mount
the inverter on the bracket unless you are sure that the mounting
frame is really firmly mounted on the wall after carefully checking.
WARNING
WARNING
WARNING
Using the mounting frame as a template, drill holes as illustrated in follow image:
The screws must be long enough to reach a depth in the wall of 11/2 inch, two screws
at the upper left side, two screw on the upper right side.
Install the mounting frame as the figure shows. Do not drill the screws
to be flush to the wall. Instead, leave 2 to 4mm exposed.
Falling equipment can cause serious even fatal injury, never mount the
inverter on the bracket unless you are sure that the mounting frame is
really firmly mounted on the wall after carefully checking.
Hang the Inverter on the wall , after the inverter is installed, as shown below:
17
18
