33
34
6.3 Country Setting and LCD Display
6.3.1 Country Setting
If it is the first time the inverter starts up after installation, LCD will quickly switch to
and stay at the country setting interface. Only the inverter is set to comply with a
certain country rule, it will work and display normally. Otherwise, LCD will always
stay at the ’Please select’ interface.
Please finish the country setting according to the following steps:
1) When at the first interface ‘Select country:’ the option is ‘VDE0126’ in default. By
single knock, countries will vary from one to another, for example, ‘France’, as Fig
6.3.1
In the lower right corner of inverter there is the LCD display. We can check inverter
running state, historical generation data, etc, on the LCD screen. Items displayed can
be changed by knock; you can also change some inverter parameters by knock.
Fig 6.3.1
Fig 6.3.2
Note:
have been preset in factory and you don't need to operate this step any more.
If you have ordered the inverter with specific country settings, the parameters
2) There are eleven countries or rules to select:
1
2
3
4
5
6
7
8
9
10
11
VDE0126
Germany
France
Italy
Greece
Hungary
Belgium
Turkey
Denmark
Spain
UK-G59
Note: if you can’t find the country you want, please contact Growatt.
3)When it comes to the country you want, double knock to enter, as Fig 6.3.3.
4) When enter the confirm interface, there are two options ‘NO’ and ‘YES’, and the
cursor will stay at ‘NO’ in default, single knock to shift between ‘NO’ and ‘YES’,
double knock to confirm your selection. When at ‘NO’, double knock will exit, when
at ‘YES’, double knock will set up. After the setting is successful, the LCD will
display”Set Country OK”, and inverter will reboot automatically.
Fig 6.3.3
Fig 6.3.4
