16
17
5
Communication
5.1 Communications software instructions
ShineNET is a PC software that communicates with Shine Inverter to analyze the
inverter work state. It is convenient for you to know the inverter real time working
state and the history work information.
Spec:
1.
Communicate with inverter by RS232 and Bluetooth.
2.
Construct net with inverter, GROmonitor and ShineNet by RS232, Bluetooth
and Internet.
3.
Two Interfaces: Multi Inverter Interface and Wave Data Interface.
4.
In Multi Inverter Interface: 9 inverters working data at the same time, you can
select your own compare inverters and parameters.
5.
In Wave Data Interface: Query the inverter real time and history power wave,
work data and error information.
6.
Multi languages: English, Simple Chinese, French, German, Spanish and etc.
Support OS: WinXP / Vista / win7 / 2000/ 2003
5.2 Monitor
After setting the software the user can monitor the inverter. The right side of the
main interface is the detailed information of inverter.
5.3 Detailed information
Detailed setting method and other functions refer to “ShineNET Manual.” in the CD.
Trouble Shooting
6
In most situations, the Inverter requires very little service. However, if Inverter is not
able to work perfectly, please refer to the following instructions before calling your
local dealer.
Should any problems arise, the LED on the front panel will be red and the LCD displays
the relevant information. Please refer to the following for a list of potential problems
and their solutions.
SYSTEM FAULT
Ground I Fault
Isolation Fault
Grid Fault
1. The ground current is too high.
2. Unplug the inputs from the PV generator and check the peripheral AC system.
3. After the cause is cleared, re-plug the PV panel and check PV-Inverter status.
4. If the problem persists please call service.
1. Check the impedance is between PV (+) & PV (-) and the PV-Inverter is earthed.
The impedance must be greater than 8M.
2. If the problem persists please call service.
1. Wait for 5 minutes, if the grid returns to normal, PV-Inverter automatically restarts.
2. Make sure grid voltage and frequency meet the specifications.
3. If the problem persists please call service.
4. Check grid usability.
No AC connection
1. Grid is not connected.
2. Check grid connection cables.
INVERTER FAILURE
PV Over Voltage
Consistent Fault
1. Check the open PV voltage; see if it is greater than or too close to 500VDC.
2. If PV voltage is less than 500VDC, and the problem still occurs, please call local service.
1. Disconnect PV (+) or PV (-) from the input, restart the PV-Inverter.
2. If it does not work, call service.
If there is no display on the panel, please check PV-input connections. If the voltage is
higher than 150V, call your local service.
During periods of little or no sunlight, the PV-Inverter may continuously start up and
shut down. This is due to insufficient power generated to operate the control
circuits.
