编号：
GR-UM-C -00
11
/
57
H
Safety screw
1
I
485 terminal (3PIN)
1
J
485 terminal (6PIN)
1
K
PV+/PV- terminal
8/8(MAC 30KTL3-X LV)
9/9
（
MAC 40KTL3-X LV
）
10/10
（
MAC 50KTL3-X LV/MV
）
12/12
（
the others
）
L
PV+/PV- metal terminal
8/8(MAC 30KTL3-X LV)
9/9
（
MAC 40KTL3-X LV
）
10/10
（
MAC 50KTL3-X LV/MV
）
12/12
（
the others
）
M
PV Removal tool
1
N
RNBS14-6
1
O
SC50-10
5
*
Warranty card
1
*
Copy of the business license
1
*
Certificate
1
*
CQCC ertificate/report
1/1
*
Packing list
1
Note: The MAC series comes standard with 50-10 copper crimp terminals. If you have copper and aluminum terminals,
please contact the supplier.
5. Installation
CAUTION
●To prevent device damage and personal injury, keep balance when moving the inverter because
it is heavy.
●Do not place the inverter with its wiring and signal terminals at the bottom contacting with
floor or any other object because the terminals are not designed to support the weight of inverter.
●When placing inverter on the floor, put foam or paper under the inverter to protect its cover.
5.1 Basic Installation Requirements
A. Ensure that the installation wall is solid enough to bear the inverter.(Inverter weight please refer to installation manual
Chapter3, 3.2 )
B. There must be enough installation space to fit the size of inverter..
C. Do not install inverter on flammable or heat-intolerant buildings.
D. This inverter is IP 65 protection, you can install it indoor or outdoor.
E. Install the inverter in the eye for easy viewing of the OLED display and maintenance work.
F. To avoid inverter performance de-rate due to the over heat, please do not expose the inverter under direct sunlight.
G. The installation humidity should be from 0-95%.
H. The surrounding temperature of inverter should be from -25
℃
~
+60
℃
.
I. Inverter should be installed in a vertically or rear tilted surface, please refer to following drawings.
