29
30
OLED display and touch button
9
9.1 Boot display
The OLED display can display the running status of the inverter, as well as various
parameters
information, and the display interface of the inverter can be switched and
the inverter parameters can be set by touching the button.
When the inverter is turned on, the OLED display interface is as follows:
Connect OK
Connect in
30S
PV1
XXXvXXXXw
PV2
XXXvXXXXw
Set parameter
Grid
XXXvXXXHz
Growatt
PV inverter
Power
XXXXw
Etotal
XXXXw
Etoday
XXXkWh
More info
Model:SXXBXXD
XXTXXPXXUXXM0
000
FW Ver：DM1.0
Fig 9.1
9.2 OLED display wake up
8
Working
Mode
8.1 Normal mode
In this mode, the inverter works normally.
Ø
When the DC voltage is greater than 250V, the energy is sufficient, and the grid
voltage frequency meets the grid-connected requirements, the inverter will convert
the energy of the solar panels into AC power and export to the grid, and the green
LED will light up.
Ø
When the DC voltage is lower than 180V, the inverter will automatically disconnect
from the grid and exit the normal operation mode. When the input voltage reaches
the requirement again and the grid voltage and frequency return to normal, the
inverter will automatically connect to the grid.
8.2 Failure mode
The inverter controls the chip monitors and adjusts the state of the system in real time.
When the inverter monitors any unexpected conditions,such as system failure and
inverter failure,the display will show the fault information.In the failure mode,the
inverter will indicate The leaves of the window will turn red and the inverter output will
be disconnected from the grid.
When the sunlight is weak or there is no sunlight,the inverter will automatically stop
running.When in shutdown mode,the inverter basically does not consume energy from
the grid or solar panels,and at the same time,the inverter's display screen and LED lights
will be turned off.
8.3 Shutdown mode
Mark
Describe
Explain
Touch mark
Single touch
Switch the display interface or
the current number plus 1
Double touch
Enter the setting state or
confirm
Triple touch
Return to the previous display
interface
Long press for 5s
The current data returns to the
default value
After
the
inverter
works
normally
for
5
minutes
,
the
OLED
display
will
be
automatically
turned
off
.
At
this
time
,
there
is
no
display
on
the
OLED
,
and
the
leaf
of
the
indicator
window
is
green
.
You
need
to
view
the
display
data
or
make
settings
to
make
the
OLED
display
again
through
touch
operation
.
