8 Working Mode
8.1
Normal mode
In this mode, the inverter works normally.
y
When the DC voltage is greater than 250V, the energy is sufficient, and the grid voltage
frequency meets the grid-connected requirements, the inverter will convert the energy
of the solar panels into AC power and export to the grid, and the green LED will light up.
^ When the DC voltage is lower than 140V, the inverter will automatically disconnect from the
grid and exit the normal operation mode. When the input voltage reaches the require-
ment again and the grid voltage and frequency return to normal, the inverter will auto-
matically connect to the grid.
8.2
Failure mode
The inverter controls the chip monitors and adjusts the state of the system in real time. When
the inverter monitors any unexpected conditions,such as system failure and inverter failure,the
display will show the fault information.In the failure mode,the inverter will indicate The leaves
of the window will turn red and the inverter output will be disconnected from the grid.
8.3
Shutdown mode
When the sunlight is weak or there is no sunlight,the inverter will automatically stop run-
ning.When in shutdown mode,the inverter basically does not consume energy from the grid or
solar panels,and at the same time,the inverter's display screen and LED lights will be turned off.
31
Summary of Contents for MOD 1 0KTL3-X
