6.5 Connect the signal cable
The MOD series inverter has an30-Pin signal connector except Vietnam models.The client signal
line port is as follows:
Fig 6.9
1.Strip the cable 10mm through the waterproof gland, thread sleeve, and tighten the
screws.
Fig 6.10
3.
Connect the client to the inverter plug until both are tightly locked on the inverter.
Fig 6.11
Remove the signal connector
1 .Press down the fastener and pull it out of the inverter.
Fig 6.12
22
Summary of Contents for MOD 10KTL3-XH
