8 Working Mode
8.1 Normal mode
In this mode, the inverter works normally.
y
When the DC voltage is greaterthan 250V, the energy is sufficient, and the grid voltage fre-
quency meets the grid-connected requirements, the inverter will convert the energy of the
solar panels into AC power and export to the grid, and the green LED will light up.
^ When the DC voltage is lower than 140V, the inverter will automatically
disconnect from the grid and exit the normal operation mode. When the input voltage
reaches the requirement again and the grid voltage and frequency return to normal, the in-
verter will automatically connect to the grid.
8.2 Failure mode
The inverter controls the chip monitors and adjusts the state of the system in real time. When the
inverter monitors any unexpected conditions,such as system failure and inverter failure,the dis-
play will show the fault information.In the failure mode,the inverter will indicate The leaves of the
window will turn red and the inverter output will be disconnected from the grid.
8.3 Shutdown mode
When the sunlight is weak orthere is no sunlight,the inverter will automatically stop running.When
in shutdown mode,the inverter basically does not consume energy from the grid or solar pan-
els,and at the same time,the inverter's display screen and LED lights will be turned off.
29
Summary of Contents for MOD 10KTL3-XH
