Error
Description
Suggest
Error 400
D C I b i a s ab-
normal
1.Restart inverter
2.If error message still exists, contact manufacturer.
Error 401
DC
Voltage
High
Fault
1.Restart inverter.
2.If error message still exists,contact manufacturer.
Error 402
O u t p u t D C
current too high.
1.Restart inverter.
2.If error message still exists,contact manufacturer.
Error 403
O u t p u t c u r r e n t
unbalance
1 .After shutdown,Check the output current is not balanced.
2. If the error message still exists, contact manufacturer
Error 404
bus sample fault
1 .Restart inverter.
2.If error message still exists,contact manufacturer.
Error 405
Relay fault
1 .Restart inverter.
2.If error message still exists,contact manufacturer.
Error 406
Init model fault
1.Reset mode
2.If error message still exists,contact manufacturer.
Error 407
AutoTest failure
1 .Restart inverter.
2.If error message still exists,contact manufacturer.
Error 408
NTC
Temperature
too high
1 .After shutdown,Check the temperature, normal restart the in-
verter
2. If the error message still exists, contact manufacturer
Error 409
Bus voltage abnor-
mal
1.Restart inverter.
2.If error message still exists,contact manufacturer.
Error 410
C o m m u n i c a -
t i o n board and con-
trol p a n e l sampling
battery voltage is in-
consistent
1 .Restart inverter
2.If error message still exists, contact manufacturer.
Error411
Communication
fault
1 .After shutdown,Check communication board wiring 2. If the
error message still exists, contact manufacturer
Error 412
Temperature sensor
connection is abnor-
mal
1 .After shutdown,Check the temperature sampling module is
connected properly
2.If the error message still exists, contact manufacturer
44
Summary of Contents for MOD 10KTL3-XH
