33
34
If customer need SPH inverter stop working, customer must disconnect all the energy
source, then SPH inverter will turn into shutdown mode automatically.
The following is the shutdown procedure:
Ø
Shutdown the PV side
Ø
Turn off battery switch.
Ø
Shut down AC power of SPH. Then you can see the both LED and LCD of SP are off.
NOTICE:
After all the actions are done, you still have to wait for more than 5 minutes.
6.2.6 Shutdown mode
6.3 Country setting
Growatt can provide various regulations of the machine, after customers receive the
machine, according to their country, by dialing DIP switch to set the corresponding
regulations. Following is the DIP switch introduction.
Chart 6.1
The DIP switch is composed of five-digit binary number PINS. The different combination
of the five PINS can represent different inverter's model, which is corresponding to the
local grid standard. Each small white PIN has two statuses, when set upward to “ON”, its
value turns to “1”, when set downward, its value turns to “0”. Concerning the matching
of the PIN status and the country safety standard, please refer to the table below:
DANGER
Caution :
When you setting the DIP, you must turn off PV switch, AC breaker
and Battery to make sure all of the power are off.
Caution:
1. After setting the DIP, please power on the inverter and check
the model display (show as 6.3.1). If the model display is match
what you want, it means your setting is successful.
2. You need to calibrate the time that the machine is showing
after inverter starts up.
If the country is set incorrectly, please shut down the inverter and
set again.
6.3.1 Switch to country table
DIP switch status
Country/region / regulations
Model display
6
5
4
3
2
1
ON
DI
P
VDE 0126
GT0XXXXXX1
6
5
4
3
2
1
ON
DI
P
6
5
4
3
2
1
ON
DI
P
6
5
4
3
2
1
ON
DI
P
6
5
4
3
2
1
ON
DI
P
6
5
4
3
2
1
ON
DI
P
Queensland
GT0XXXXXX2
AS 4777
GT0XXXXXX3
CEI 0-21
GT0XXXXXX4
Greece
GT0XXXXXX6
VDE-AR-N 4105
GT0XXXXXX7
G98
GT0XXXXXX8
6
5
4
3
2
1
ON
DI
P
