Chart 5.30
Chart 5.31
Note:
1.
If you are using a lead-acid battery, you do not need to install this communication cable.
2.
The CAN battery communication and 485-2 battery communication can’t be installed at same time,
please select the correct communication method according to the battery manual.
3.
If the cable such as “485-2” cable or “CAN” cable is not used, please do not remove the filler plug from
the cable support sleeve.
5.4.8 Connection of DRMS terminal (Australia only)
When SPH is applied to Australia, the DRMS terminals need to be connected, the connection way appears
as follows:
1.
Unscrew the swivel nut from the cable gland.
2.
Thread the swivel nut over the “DRMS” cable.
3.
Press the cable support sleeve out of the cable gland.
4.
Remove the filler plug from the cable support sleeve.
5.
Route the “DRMS” cable through an opening in the cable support sleeve.
6.
Thread the “DRMS” cable through the cable gland.
