8
Assemble DC Connector
Strip the cable 6-8mm,then connect the bare wire core into core tube of connector.
Crimp contact barrel by using a hex crimping die. Put the contact barrel with striped cable in the corresponding
crimping notch and crimp the contact. Insert the core tube into slot of connection until hear the sound
indicating fit in place.
Tighten the nuts to finish the wiring.
Warning: Risk of electric shock! Before shifting solar panel, disconnect the pump inverter AC and DC. Besides,
allow 5-minute internal capacitance discharging.
Assemble AC Connector
AC connnector gets connection with the pump through 4 wires (U wire, V wire, W wire and PE wire)
Remove the parts of teh AC connection plug from the accessory bag. Guide the pressure screw sealing right, threaded
sleeve over the AC cable.
Socket element threaded sleeve sealing ring pressure screw
Insert the stripped and bared conductors U, V, W, PE in to screw terminals with sign U, V, W, PE on the socket element
and tighten the screws.
Connect the conductors
