11
Revision date: 08.30.18
106205_06_07_08
Assemble Frame
Gather parts:
• All rafter assemblies and purlin pipe.
• Band clamps (#QH1402)
• Cross connector (#102548)
• 5/16" x 2-1/2" machine bolts (FAG336B)
and 5/16" nuts (FALB02B)
• Lifts, ladders, and assistants; Rope, strap,
or cable.
BASIC FRAME ASSEMBLY TIPS
• Enlist the services of experienced assistants.
• Never leave end rafter assembly standing without temporary supports (straps, braces, etc.).
• Never remove end rafter temporary braces or straps without first connecting end rafter to at least two
set interior rafters using purlin pipes and clamps.
• Use lift to set rafters; small building rafters can be set by hand when assistants are available.
• Wear safety gear at all times during frame assembly.
Complete these steps to assemble frame:
1. Use photo below and on next page to stand and set first end rafter. Ensure end clamps on end rafter are oriented as shown in diagrams for end rafter
assembly procedure presented earlier.
Clamps cannot be removed and reinstalled without first separating rafter pipes.
ATTENTION:
Secure rafter to lift using straps. Do not attempt to lift and move rafter without securing properly to lift. Enlist the services of a qualified,
experienced contractor if needed.
Do not attempt if you have never used a lift!
